Ecoinformatics site parent site of Partnership for Biodiversity Informatics site parent site of REAP - Home


 

 

 



Terrestrial Use Case Hardware

Difference between version 32 and version 31:

At line 18 added 2 lines.
+ [http://reap.ecoinformatics.org/attach?page=TerrestrialUseCaseHardware%2Fterrestrial_hardware1.jpg|http://reap.ecoinformatics.org/attach?page=TerrestrialUseCaseHardware%2Fterrestrial_hardware1.jpg]
+ Not shown: yagi and lightening rod (goes vertical at the very top). Mount for Yagi is above anemometer cross-arm mount--we may want to reverse this if possible to interfere less with the anemometer.
At line 19 added 7 lines.
+ [http://reap.ecoinformatics.org/attach?page=TerrestrialUseCaseHardware%2Fterrestrial_hardware2.jpg|http://reap.ecoinformatics.org/attach?page=TerrestrialUseCaseHardware%2Fterrestrial_hardware2.jpg]
+ A terrible wiring job, when we deploy we should tie-off to the sides for strain relief / future sanity. Solar panel mounted upside down, I've since flipped the arm so it can be more easily mounted w/ a good incidence angle on the mast right side up. Depending on grass height, we could alternatively mount it on a leg.
+
+ [http://reap.ecoinformatics.org/attach?page=TerrestrialUseCaseHardware%2Fterrestrial_hardware3.jpg|http://reap.ecoinformatics.org/attach?page=TerrestrialUseCaseHardware%2Fterrestrial_hardware3.jpg]
+ 2 reflectometers, 2 line quantum sensors, 1 (qsosun) quantum sensor, rain gage, grounding rod and a grounding cable in background. We need to order a mount for the qsosun, and figure how to mount it so it doesn't interfere--do we need a second crossarm?
+
+

Back to Terrestrial Use Case Hardware, or to the Page History.